Characteristics and Process of Stamping Label Forming

Writer：admin Time：2023-06-20 10:42 Browse：℃

　　1. Characteristics of stamping label processing

　　During the production process, automated mechanical equipment and multi engineering automated feeding devices are applied, resulting in high production efficiency.

　　In stamping processing, there is less waste than other processes, and the waste can also be made into other small parts, resulting in high material utilization rate.

　　Under the simple stamping of a punch, parts with complex shapes, high strength, and small weight can be obtained.

　　High production volume and low manufacturing cost of parts.

　　(5) Shorten working hours, save labor, and operate easily.

　　(6) The products manufactured by the same mold have the same size and shape, and have good interchangeability.

　　Stamping label forming process

　　2. Types of stamping process for signage:

　　Produce plastic deformation of materials, including bending, drawing, forming, and compression processing

　　② Cut and separate materials, including punching and shearing processing.

   

　　3. Cut and separate the material

　　Punching and shearing processing: refers to the application of external forces above the breaking strength of the punching and shearing mold on the material, with a closed or open contour to separate one part of the material from another. This type of processing must be able to complete tasks such as cutting, cutting, punching, punching, breaking, trimming, and trimming.

　　(1) Cutting: Punch and cut the material and wool embryo according to the open contour to separate them.

　　⑵ Blanking: Separate the material from the wool embryo by punching and cutting according to the closed contour.

　　(3) Punching: Punching is the opposite of cutting, which is the process of punching and shearing the materials inside the part in a closed contour to separate them, and the cut pieces produced are usually turned into waste.

　　(4) Punching: Punch and cut the opening groove at the end of the material.

　　(5) Cutting: Punching and cutting flat, curved, or hollow hair into two or several parts.

　　(6) Edge trimming: Remove any unevenness or excess edges around the extracted or compressed parts.

　　(7) Edge trimming: Edge trimming processing is the use of a punching machine's reprocessing and cutting method to cut the machining amount reserved for irregular surfaces or outer edges, in order to obtain accurate dimensions and smooth vertical shear sections.