Signage process, stainless steel signage process requirements

Writer：admin Time：2023-06-12 11:33 Browse：℃

　　Signage process, stainless steel signage process requirements, stainless steel signage is a special material. Its manufacturing process is more extensive than copper and aluminum plates. But it has excellent corrosion resistance to atmospheric and freshwater media, and after corrosion, polishing, and wire drawing, the decorative effect is very beautiful. Therefore, the fastest corrosion method for stainless steel is electrochemical corrosion. Also known as electrolytic corrosion. Due to the fact that electrochemical corrosion can cause ink detachment during the symbol corrosion process, this symbol is not suitable for electrochemical corrosion, especially for precision drawings.

　　1、 Precautions for making stainless steel signs

　　Signage process, stainless steel signage process requirements, good dry adhesive quality, firmly adhered to stainless steel plates, and not easy to peel off after baking.

　　If some directional paint peels off, the non stick part can be carved and set in the defective direction. Use a small brush to touch up the paint and immediately remove the non stick part, which can be corrected.

　　2、 Stainless steel label manufacturing process flow

　　Signage process, stainless steel signage process requirements, data preparation, selection standards, and plate requirements.

　　The graphic files of stainless steel signs are organized by a computer, and then the layout of the stainless steel signs is engraved using a dry adhesive typewriter.

　　Heat and paste the engraved stickers on the board to make the film flat and firm. Wear Oven glove, heat the stainless steel label to the hot position in the honeycomb coal furnace (about 90-100 ℃, estimated), and then remove the words and lace to form a hollow plate stainless steel label. After acid cleaning or sanding, the paint and steel plate are firmly combined.

　　Clean and corrode stainless steel signs, prepare for painting. The paint can be baking paint (an oven is required) or car metal paint.

　　After painting and drying, remove the residual adhesive on the stainless steel label and complete the product spraying.

　　Label process, stainless steel label process requirements, and final defect handling: If the stainless steel label is left on the top of the tape, it can be removed from the stainless steel label with a cloth.